Gas burner

Gas Burner System

Gas burners

We can supply amazing Avanzini gas burners for all traditional and commercial ovens and tubular gas burners for stainless steel ovens.

Below you will find only few examples with descriptions — please contact us for more details. We offer full range of Drago P, D, Six  Avanzini Bruciatori burners.

Tubular gas burners are available from our online shop.

Whatever oven type you operate – mobile, restaurant /commercial or garden — we can supply a dedicated gas burner for your existing oven or a new amazing pizza oven fitted with an Avanzini gas burner.

Please note that our Mobile Wood Fired Pizza Oven are also available as “Drago edition” with a bespoke designed Avanzini gas burner. Important note! All ovens fitted with a gas system can also be fired with wood as normal wood fired pizza oven so you will have a fuel choice between Gas and Wood.

Drago P1 PLUS

Drago P1 Plus elbow burner

Product specification

Indications for the position of the Drago burner inlet hole in the hotplate of the wood oven, view from above. The hole may be drilled either on the right or on the left.

The gas supply must be delivered through a galvanized pipe Ø 1/2” or equivalent copper pipe, located at the burner
inlet hole, 5 cm (2”) from the ground. Install the gas ONOFF tap in a suitable position upstream.
Remember to clean the flue to free it of any ash that might have been produced by the combustion of the wood.

This model have manual thermostat.

Product attributes

Up to50 bargas
pressure
Up to2.54 Nm3/hgas
volume
Up to24 Kwheating
capacity
HEATING CAPACITYGAS PRESSUREGAS VOLUMEGAS CONNECTIONWEIGHT
Min KwMax KwMin Kcal/hMax Kcal/hMin BTUMax BTUMin mbarMax mbarMin Nm3/hMax Nm3/hInchesin Kg
P1 PLUS11249,40020,64037,50081,9001,5501,162,541/24

Drago P1 Side-Entry

Drago P1 side-entry burner

Product specification

Indications for the position of the Drago P1 burner inlet hole in the oven side wall. The hole may be drilled either on the right or on the left: the steel sleeve (through which the burner flange will pass) has a diameter of 110 mm (= 4.3”) and must rest on the oven floor. The center of the 110 mm ø hole must be 55 mm (= 2.2”) above the oven floor.

The natural gas supply must be delivered through a galvanized pipe Ø 1/2” or equivalent copper pipe, located at the burner inlet hole, 5 cm from the ground. Install the gas ON-OFF tap in a suitable position upstream. Remember to clean the flue to free it of any ash that might have been produced by the combustion of the wood.

This model have manual thermostat.

Product attributes

Up to50 bargas
pressure
Up to1.58 Nm3/hgas
volume
Up to15 Kwheating
capacity
HEATING CAPACITYGAS PRESSUREGAS VOLUMEGAS CONNECTIONWEIGHT
Min KwMax KwMin Kcal/hMax Kcal/hMin BTUMax BTUMin mbarMax mbarMin Nm3/hMax Nm3/hInchesin Kg
P1 side-entry6155,00013,00020,47051,1802,5500,631,581/24

Drago Electronic — 2 Flames

Drago Electronic - 2 flames burner

Product specification

Indications for the position of the Drago burner inlet hole in the hotplate of the wood oven, view from above.

The hole may be drilled either on the right or on the left, as long as it is in the rear semicircle, opposite the oven mouth.

The burner will have to face towards centre of the oven floor, with F1 (first flame) positioned towards the oven mouth.

This model have electronic thermostat.

Product attributes

Up to35 bargas
pressure
Up to3.50 Nm3/hgas
volume
Up to34 Kwheating
capacity
HEATING CAPACITYGAS PRESSUREGAS VOLUMEGAS CONNECTIONPOWER SUPPLYWEIGHT
Min KwMax KwMin Kcal/hMax Kcal/hMin mbarMax mbarMin Nm3/hMax Nm3/hInchesVoltin Kg
Drago electronic – 2 flames
NATURAL GAS
6345,00029,20010250,603,501/2220V monophase11
Drago electronic – 2 flames
LPG
6345,00029,20020350,201,221/2220V monophase11

Drago P2

Drago P2 vertical burner

Product specification

Indications for the position of the Drago burner inlet hole in the hotplate of the wood oven, view from above. The hole may be drilled either on the right or on the left.

The gas supply must be delivered through a galvanized pipe Ø 1/2” or equivalent copper pipe, located at the burner inlet hole, 5 cm (2”) from the ground. Install the gas ON-OFF tap in a suitable position upstream.

Remember to clean the flue to free it of any ash that might have been produced by the combustion of the wood.

This model have electronic thermostat.

Product attributes

Up to30 bargas
pressure
Up to3.50 Nm3/hgas
volume
Up to34 Kwheating
capacity
HEATING CAPACITYGAS PRESSUREGAS VOLUMEGAS CONNECTIONWEIGHT
Min KwMax KwMin Kcal/hMax Kcal/hMin mbarMax mbarMin Nm3/hMax Nm3/hInchesin Kg
Drago P26345,00029,20010300,603,501/26

Drago P1

Drago P1 vertical burner

Product specification

Indications for the position of the Drago burner inlet hole in the hotplate of the wood oven, view from above. The hole may be drilled either on the right or on the left.

The gas supply must be delivered through a galvanized pipe Ø 1/2” or equivalent copper pipe, located at the burner
inlet hole, 5 cm (2”) from the ground. Install the gas ONOFF tap in a suitable position upstream.
Remember to clean the flue to free it of any ash that might have been produced by the combustion of the wood.

This model have manual thermostat.

Product attributes

Up to50 bargas
pressure
Up to1.58 Nm3/hgas
volume
Up to15 Kwheating
capacity
HEATING CAPACITYGAS PRESSUREGAS VOLUMEGAS CONNECTIONWEIGHT
Min KwMax KwMin Kcal/hMax Kcal/hMin BTUMax BTUMin mbarMax mbarMin Nm3/hMax Nm3/hInchesin Kg
P16155,00013,00020,47051,1802,5500,631,581/24

Please feel free to contact us for prices and more details